•Command C = CasNT serves to set the time to reach the temperature.

•The set time to reach the temperature applies to all further increases and decreases in temperature until the next change with the C (CasNT) or R (Ramp) command.

•When starting the program, the rate of temperature change is taken from the manual mode (Rate of temperature change).

•If the required time to reach the temperature is required, it is necessary to enter the time first and then the block with the temperature.

•The equivalent of this command is a command Ramp (article Command R (Ramp)), which instead of the time to reach the temperature, directly sets the rate of temperature change in degrees Celsius per minute.

 

After pressing the button with the command C (CasNT), the screen for entering the time to reach the temperature will appear.

 

 

•Range of time to reach temperature: 0:01 to 9999:59 (min:sec).

•The value can be entered using the numeric keypad or the up and down arrows.

•If we hold the up or down button, the value will change faster and faster.

•An incorrectly entered value cannot be confirmed with the button  (OK).

•With a button  (Back) we cancel the addition or change of the block.