•Command D = Delay is used to set the dwell time at the currently regulated temperature.

•This command is also described in the article Temperature delay in manual mode.

•When entering the dwell time 0:00 will be displayed Cont which means the delay will be infinite.

•If it is set Cont temperature, the program must be switched off manually or it will be interrupted in the event of a fault.

 

After pressing the button with the D (Delay) command, the screen for setting the delay time will appear.

 

 

•Delay time range: 0:01 to 9999:59 (min:sec) or Cont (infinite delay).

•The value can be entered using the numeric keypad or the up and down arrows.

•If we hold the up or down button, the value will change faster and faster.

•An incorrectly entered value cannot be confirmed with the button  (OK).

•With a button  (Back) we cancel the addition or change of the block.