Temperature delay

After pressing the delay button on the program launch preparation screen, a universal screen is displayed for entering various values (parameters) of the controller. The desired delay (time of holding at the temperature) can be entered in the range of 0:00 to 9999:59 with an accuracy of one second. If we enter a value of 0:00 (also referred to as Cont) the delay will be permanent (the set temperature will be regulated continuously until manual shutdown or a possible malfunction). It is not possible to enter a value outside the allowed range. The value can be entered using the numeric keypad or the increase and decrease buttons. The entered value is confirmed with the appropriate button, or it is possible to return to the previous screen without confirmation using the Back button.

	Description of the value
	A brief description of the value or parameter that we will enter, with an indication of the units.

	Value range
	The allowed range for entering the desired temperature delay is 1 second to 9999 minutes 59 seconds.

	Input value
	At this point on the screen, we see the value or parameter that we enter.

	Numeric keypad
	The numeric keypad, similar to a calculator, allows you to enter the desired value. The button <- is used to delete the last digit entered.

	Back
		With this button, we can return to the previous screen while maintaining the original value (parameter).

	Increase value
		Button to increase the desired delay. It is possible to hold the button and thereby repeatedly increase the set delay at an accelerated rate.

	Decrease the value
		Button to decrease the desired delay. It is possible to hold the button and thereby repeatedly reduce the set delay rapidly.

	Confirm
		Confirming the entered value and returning to the previous screen - article Preparing to run the program.