There may be cases when we want to start the program only from a certain point (block). For this case, the Start program from block button is used. This function is available (button display) if it is in Settings (article Option to skip and pause) allowed to skip blocks. Furthermore, this button is not displayed for the first (standard program launch) and the last block. If the program is changed in the same place, the button for saving the program will preferentially appear (article Save program changes).

To exit the management of program blocks, we use the button  (Back). When using the button  (Skip), a confirmation button will appear in place of the program information (same as Program deletion). The button gradually disappears and after about 5 seconds it disappears and the program information appears again. If the button is pressed during these 5 seconds, the selected program will start from the currently selected block. All parameters for the previous blocks (outputs, ramp speed) are set as if the program was executed from the beginning. The controller will automatically return to the home screenand the controller starts executing the program from the selected block.