By pressing the  (Stop) button on the home screen while the program is running, we are taken to the screen for preparing to end the program. If the option to skip (a program block) is enabled in Settings (article Option to skip and pause), a corresponding brown button will appear in the button bar (see the top image).

 

If we press the  (Skip) button, a confirmation button  (OK) will appear in the button bar for 5 seconds, replacing the Pause button.

If we press the  (OK) button before it disappears, the controller will end the current program block and begin executing the next one. If a ramp is running in the manual program, the set temperature will start to be regulated immediately, and the delay at this temperature will begin counting down. If there is already a delay in the manual program, the program will end.