•Command A = Alarm is used to wait for the specified real time.

•With this command we can synchronize the program with real time. For example, due to a change in the ramp speed or a power failure, the program may not follow the times in the program curve exactly.

•When executing this command, the controller waits for the specified time in hours and minutes.

•While waiting, the last set temperature is regulated (as with the delay Příkaz D (Vydrz)).

•With the help of the command, it is possible to program the long-term, time-accurate operation of the device.

 

After pressing the button with the command A (Alarm), the screen for entering the hours and minutes will appear.

 

 

•The range of the A (Alarm) command parameter is 00:00 to 23:59 (hours : minutes).

•The value can be entered using the numeric keypad or the up and down arrows.

•If we hold the up or down button, the value will change faster and faster.

•An incorrectly entered value cannot be confirmed with the button  (OK).

•With a button  (Back) we cancel the addition or change of the block.